Description

For mold that has stuck to tile joints and silicone.
Since it adheres well, it is easy to use on mold in the bathroom and window frames.
Anti-mold effects last for approximately 60 days.
Since it is a gel, it adheres firmly without dripping.
Simply leave it for 1-2 hours and the chlorine in the gel will penetrate deep into the mold and remove it.
A low-odor type with less of the pungent smell that is typical of chlorine-based products.
Since it is a colored gel, it is easy to check and you will not forget to apply or rinse it off.

How to use

Depending on the material, discoloration may occur. Be sure to test in an inconspicuous place.

1. Before use, be sure to ventilate the room by opening windows and doors and turning on the exhaust fan. Wear rubber gloves.

2. Thoroughly wipe off dirt and moisture, apply to envelop mold stains, and leave for 1-2 hours. After use, close the cap and store in a cool, dark place.

3. After use, rinse with water or wipe thoroughly. Always wash your hands after use, then wash your face and eyes.

If mold is difficult to remove, repeat steps 2 and 3. Leave stubborn mold for 1-2 hours, then scrub with an old toothbrush to remove it. (If the gel becomes difficult to remove if left for a long time after application, scrub with an old toothbrush to remove it.)

Uses: Removing mold stains from rubber packing, caulking, bathroom walls, tiles, joints, bathroom mats, small items, and shower curtains.
Items that cannot be used: Metal products such as enamel, aluminum, and brass, sand walls, fiberboard walls, plaster walls, wallpaper walls, decorative steel walls of unit bathrooms (magnetic type), animal hair brushes, wooden products, and wire-reinforced glass window frames.

Ingredients

Hypochlorite, potassium hydroxide (1.0%), surfactant (alkylamine oxide), gelling agent, stabilizer